Strut bar vertical L= 2,0-2,7 m

0931401.000

lei1,00

•…Quick and smooth adjustment from 2 000 to 2 700 mm or from 2 500 to 3 200 mm
•…Built-in brake of the telescope holds the inner tube in the set position, even when the closing mechanism is in the released position
•…The spring pre-tensioned to about 160 kg, located in the lower part of the vertical bar ensures that the pressure at both ends of the bar does not exceed this force
and permanent deformation – damage – of the box body does not occur
•…In the lower part of the bar, there is a plate a bit larger than the bar, its area is sufficient for creating the needed friction force. At the opposite “upper” end, there is
a pushing plate with o 110 mm dimensioned so that it spreads the pushing force as much as possible and therefore protects the ceiling structure against permanent
deformation.
•…Both plates are rotary and tilting and therefore allow for use of a vertical bar up to an angle of 15°
•…The surface of both plates is fitted with a material of raw rubber, which ensures that a friction coefficient approaching the value of “1” is achieved
WARNING : with the larger design “2500 – 3200 mm”, the securing and sliding mechanism is reversed, i.e. in the lower part of the bar, for more accessible control. For
this reason, both plates are also exchanged..

Greutate

Dimensiuni
Material
SKU: 0931401.000

•…Quick and smooth adjustment from 2 000 to 2 700 mm or from 2 500 to 3 200 mm
•…Built-in brake of the telescope holds the inner tube in the set position, even when the closing mechanism is in the released position
•…The spring pre-tensioned to about 160 kg, located in the lower part of the vertical bar ensures that the pressure at both ends of the bar does not exceed this force
and permanent deformation – damage – of the box body does not occur
•…In the lower part of the bar, there is a plate a bit larger than the bar, its area is sufficient for creating the needed friction force. At the opposite “upper” end, there is
a pushing plate with o 110 mm dimensioned so that it spreads the pushing force as much as possible and therefore protects the ceiling structure against permanent
deformation.
•…Both plates are rotary and tilting and therefore allow for use of a vertical bar up to an angle of 15°
•…The surface of both plates is fitted with a material of raw rubber, which ensures that a friction coefficient approaching the value of “1” is achieved
WARNING : with the larger design “2500 – 3200 mm”, the securing and sliding mechanism is reversed, i.e. in the lower part of the bar, for more accessible control. For
this reason, both plates are also exchanged..